Before you start
Use this for a small picture-nail hole, not a loose wall anchor, a ceiling repair, damp drywall or a spreading crack. Before disturbing paint in a pre-1978 or unknown-age home, resolve the lead-paint risk with a qualified lead-safe professional. Do not sand or scrape an unknown old coating.
Gather your supplies
Check off what you have before you start.
Tools to grab
Materials
Check and clean the empty hole
Start with an empty picture-nail hole. Look for dry, firm drywall around the puncture. Soft material, a water stain or a recurring crack needs its cause addressed before patching. An opening left by a wall anchor may need a different patch.
Protect the floor. Gently smooth a rough or raised edge with a fine-grit sanding sponge, without enlarging the hole or tearing more of the wall paper. Clear loose crumbs and dust with a soft cloth or slightly damp sponge, then let the spot dry. This preparation is only for a coating whose condition and lead-paint risk have been resolved as described above.
Press in a little filler
Place a small amount on a flexible putty knife and press it into the hole. Draw the blade across the spot to remove the excess and leave the patch nearly level with the wall.
Avoid building a mound around the hole. A raised edge will show through paint and creates more finishing work. Clean stray filler from the surrounding paint while it is workable.
Let it dry, then check for a dip or ridge
Wait until the filler is fully dry under the conditions on its label. A cool or damp room can change the wait. If the patch has sunk below the surface, add a thin second coat and let it dry again.
Shine a light across the wall from the side. A ridge casts a shadow; a dip leaves a hollow. For a sandable filler, lightly pass a fine-grit sanding sponge over the fully dry patch until it is level, using the product's required dust protection. Wipe away the dust with a damp sponge or suitable cloth. Keep the repair flat rather than making a larger smooth-looking bump.
Check the surface rather than its color: a hump needs careful leveling after drying; a hollow needs another thin application. A flush patch follows the surrounding wall plane. Paint does not fill a dip or flatten a mound.
Prime and test the paint match
Check the filler and paint labels for a primer requirement. If either requires one, prime the patch with a compatible product and let that coat dry as directed before painting. If neither calls for primer, paint the dry, finished patch directly. Use matching wall paint and the same kind of brush or roller as the surrounding finish where practical.
Check the spot in room light and side light. Old paint, sheen differences and roller texture can make a touch-up visible even when the patch is flat. If it still stands out, repainting to a natural corner may blend better than repeatedly enlarging the spot.
Check your work
- The dried patch is flush, without a ridge or dip.
- The filler and any primer were dry and ready for the next coat before painting.
- The dry paint has been checked for color, sheen and texture.
Sources & product instructions
Match the instructions to the product and conditions in your home.