Skip to guide
Licensed & Insured · Serving Great Falls, Montana Free Quotes: (406) 315-0711

Kitchen fixes · Beginner DIY

Why your cabinet door rubs: checks before adjustment

Find where the door touches, remove an obstruction and check for a loose mounting screw. These checks help you decide whether the next step is hinge adjustment, damaged-mounting repair or help with the cabinet itself. The hinge descriptions apply to the concealed type with a round cup recessed into the back of the door.

By Great Falls Handyman · · Updated

Project timeA short inspection; any repair or model-specific adjustment is a separate task

Skill levelBeginner · check the scope below

On this page
  1. Find where the door catches
  2. Check the mounting screws
  3. Record the hardware and the remaining fault
  4. Choose the next step from what you found
Check your work

Before you start

Work on a manageable cabinet door and support it while checking the hinges. A loose cabinet box, bent hinge, stripped screw hole or heavy glass-front door needs suitable repair help. Do not remove mounting screws from an unsupported door.

Gather your supplies

Check off what you have before you start.

Tools to grab

Materials

Record where the door rubsCheck the center gap
Illustration: Record where the door rubs. Front view: look for where the door rubs. The diagram shows a gap check, not a hinge screw or turning direction.

Find where the door catches

Open and close it slowly. Look for contact with a neighboring door, the cabinet frame or an item inside. Move a pan or shelf item that projects into its path before adjusting the hardware.

With the doors closed, photograph the gaps at the top, bottom and middle. An uneven center gap helps show which edge needs to move, and the photo gives you a starting reference. A gap that tapers from top to bottom shows a tilt; an even but narrow gap suggests sideways clearance. Neither observation identifies which screw to turn.

Check the mounting screws

Support the door. Mounting screws fasten the hinge cup to the back of the door or its plate to the cabinet; adjustment cams are the screw-like adjusters within the hinge mechanism. Only gently snug an obviously backed-out mounting screw you can identify, using a hand screwdriver. Leave an uncertain screw alone and photograph it for identification.

If that fixes the rubbing, leave the adjustment screws alone. A screw that spins without gripping needs its mounting repaired; turning an adjustment screw will not repair the hole.

Record the hardware and the remaining fault

If rubbing remains, photograph the whole open hinge, its attachment to the cabinet, any stamped brand or part number, and the closed-door gaps. Record the exact contact point and whether the door is tilted, too close to its neighbor or sitting farther out than the cabinet front.

For example: “Left door touches the neighboring door at the top; lower center gap is wider. Mounting screws grip. No bent metal seen. Hinge marking and open-hinge photos attached.” This is an illustrative diagnostic record, not a repair result. It gives a supplier or repairer specific evidence to work from.

Choose the next step from what you found

If removing an obstruction or snugging an identified mounting screw stops the rubbing, test several normal openings and stop there. If a screw spins, the plate moves or a hinge is bent, the mounting or hardware needs repair before adjustment. A loose or visibly distorted cabinet needs assessment.

If the mounting is sound but the gaps remain wrong, obtain instructions matching the hinge model. The linked Blum H002 sheet is one example: its separate cams control side, height and depth. It is not a screw-location guide for every concealed hinge. Compare the actual hardware with the sheet before starting a separate adjustment procedure; if it does not match, use the photos and markings to obtain the correct instructions.

Check your work

  • The contact point and any loose or damaged mounting are identified.
  • An obstruction or loose-screw fix has been tested through normal opening and closing.
  • If rubbing remains, the hinge details and gap photos are ready for model-specific instructions or repair help.

Sources & product instructions

Match the instructions to the product and conditions in your home.

Keep the fix-it list moving.

← All DIY guides
Call (406) 315-0711